Opens with a burnt hand by accident; looking at the delivery-order numbers these days, no more grind — home for National Day, with gear: multimeter, AWithZ spot welder, the ‘fake’ cells bought online (a joke), a small soldering iron, solder wire, the bought cells, nickel strip; also found a power bank at home (3.7V 10,000mAh) and opened it — of the five cells, three are different and not connected together, two are connected; turns out those three are fake Li-ion cells, ‘fake Li-ion cells have such a long history’; measured no voltage on the three, removed them with the iron; red +, black −; the good ones and the new cells go in parallel and back in; nickel-strip leftovers, only this tape at home for insulation. At the key moment out comes the AWithZ spot welder, because it’s small and light — bringing the big welder home would be too heavy and a hassle; screen shows gear 3.2, ‘set it to about 5’; 0.15 nickel-plated steel strip is a lot thicker, a layer of 0.1 stacked on top; welded, + and − soldered with the iron; (BGM) hand straight-up burnt with a blister; power bank assembled, charge the phone as a test before fitting the shell; shell glued on. Comments: the pulse is too long, it’s arcing (so that’s it, thanks); get an internal-resistance tester and match cells, it’ll last longer (coming later); a nickel-strip short did it (stay safe); can it still be saved (isn’t that what you’re doing); put those two in as well (they’ve been around too long, no good).